Fabric-Duino


The Fabric-Duino is an Arduino clone for fabric. And for connectors one can make small wire eye.

All Paper-Duino version will works as well, but the smaller version is much handier.


Paper PCB

Workaround

01. Iron the printout on fabric:

02. Cut a Copper-Stripe-Board to the right sice:

03. Solder all parts:

The back should looks like that:

For wireing parts like LEDs and switches one need some Conductive Thread and a needle.


Software

One should first burn the bootloader on the chip: Burning the Bootloader
For uploading a scetch one need a Serial to USB board or: The Arduino as a Serial Adapter


Parts

  • Atmega328
  • 1 LED
  • voltage converter 7805
  • crystal 16MHz
  • 1 elkos 100µF
  • 4 capacitors 100nF
  • 2 capacitors 22pF
  • diode 1N4007
  • resistors: 1x 330Ohm, 2x 470Ohm, 1x 10kOhm
  • push button
  • pin headers & sockets
  • battery clip

License

The Fabric-Duino was designed by Wolfgang Spahn 2017.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Creative Commons License