This is an old revision of the document!
Table of Contents
Paper-AVRISP mkII
Am AVRISP mkII clone made with Paper-PCBs. The board is based on the ProMicro with the Atmel32U4 chip.
Pro Micro Modification
TX Line Connection:
Solder a wire between the resistor of the TX LED and A0.
Close the Jumper In putting a little bit of solder on J1 of the Pro Micro Clone you close the jumper and bypass the voltage converter of the board.
Knowledge
The Arduino Pro Micro clone
https://www.sparkfun.com/products/12640