Programming the ATtiny

Here is a short manual for programming an ATtiny with the Arduino IDE.

First install the ATtiny support for the Arduino IDE.
1.In the preferences dialog of the Arduino IDE type in the “Additional Boards Manager URLs” field that URL:

2. In the board manager install the ATtiny librarie by David A. Mellis (
3. Connect the ATtiny with your AVRISP programmer like that:

4. Upload the blink programm (use pin 0 instead of pin13).



This manual was made by Wolfgang Spahn 2016-20.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Creative Commons License