Differences
This shows you the differences between two versions of the page.
|
raspberry_boards:raspberry_io_board [2015/10/22 15:42] admin |
raspberry_boards:raspberry_io_board [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ---- | ||
| - | ==== Raspberry In Output Board ==== | ||
| - | ---- | ||
| - | {{ :raspberry_boards:paper-duino-pi_0998.jpg?300 |}} | ||
| - | |||
| - | Here is a small connector board for the General Purpose Input/Output (GPIO) on Raspberry Pi.\\ | ||
| - | This connector is a great help when you use it in combination with an breadboard. | ||
| - | |||
| - | {{ :raspberry_boards:paper-duino-pi_0993.jpg?200 |}} | ||
| - | |||
| - | For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] | ||
| - | |||
| - | The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. | ||
| - | |||
| - | {{ :raspberry_boards:paper-duino-pi_0984.jpg?200 |}} | ||
| - | |||
| - | {{ :raspberry_boards:paper-duino-pi_0989.jpg?200 |}} | ||
| - | |||
| - | ---- | ||
| - | ==== Paper-PCB ==== | ||
| - | |||
| - | {{:raspberry_boards:raspberry_in_output_board_11.jpg?100|}} | ||
| - | |||
| - | {{:raspberry_boards:raspberry_in_output_board_11.xcf.zip|raspberry_in_output-board.zip}} | ||
| - | |||
| - | ---- | ||
| - | ==== Parts ==== | ||
| - | * 2x 26 pin female Ribbon Socket Connector | ||
| - | * 26 pin male Shrouded Box Header | ||
| - | * flat ribbon cable (26) | ||
| - | |||
| - | ---- | ||