Differences
This shows you the differences between two versions of the page.
|
arduino_clones:fabric-duino [2017/03/09 23:13] admin |
arduino_clones:fabric-duino [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Fabric-Duino ===== | ||
| - | {{ :arduino_clones:fabric-duino_011229.jpg?400 |}}\\ | ||
| - | The Fabric-Duino is an Arduino clone for fabric. And for connectors one can make small wire eye.\\ | ||
| - | {{ :arduino_clones:duino-shirt.jpg?400 |}}\\ | ||
| - | All Paper-Duino version will works as well, but the smaller version is much handier.\\ | ||
| - | ---- | ||
| - | ==== Paper PCB ==== | ||
| - | {{:arduino_clones:fabric-duino_02.jpg?300|}}\\ | ||
| - | {{ :arduino_clones:fabric-duino_02.zip |}}\\ | ||
| - | |||
| - | ---- | ||
| - | 01. Iron the printout on fabric:\\ | ||
| - | {{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ | ||
| - | 02. Cut a Copper-Stripe-Board to the right sice:\\ | ||
| - | {{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ | ||
| - | 03. Solder all parts:\\ | ||
| - | {{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ | ||
| - | The back should looks like that:\\ | ||
| - | {{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ | ||
| - | For wireing parts like LEDs and switches one need some Conductive Thread and a needle.\\ | ||
| - | |||
| - | ---- | ||
| - | For uploading a scetch one need the Adappter-Board and a Serial to USB board like for the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]].\\ | ||
| - | |||
| - | ---- | ||
| - | ~~socialite:icon facebook twitter googleplus reddit tumblr~~ | ||
| - | |||
| - | ---- | ||
| - | ~~DISCUSSION~~ | ||