Differences
This shows you the differences between two versions of the page.
|
arduino_boards:motor_control_board [2014/07/23 15:43] admin |
arduino_boards:motor_control_board [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ---- | ||
| - | **Motor Control Board** | ||
| - | ---- | ||
| - | |||
| - | This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports.\\ | ||
| - | - Forward: ON - OFF\\ | ||
| - | - Stop: OFF - OFF\\ | ||
| - | - Backward: OFF - ON\\ | ||
| - | Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.\\ | ||
| - | With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino. | ||
| - | {{ :arduino_boards:motor_control_board_02.jpg?300 |}}\\ | ||
| - | {{ :arduino_boards:motor_control_board-back_1263.jpg?300 |}}\\ | ||
| - | |||
| - | ---- | ||
| - | **Paper-PCB** | ||
| - | |||
| - | {{:arduino_boards:motor_control_board_21_pub.jpg?100|}}\\ | ||
| - | {{:arduino_boards:motor_control_board_21.xcf.zip|}} | ||
| - | |||
| - | ---- | ||
| - | **Code** | ||
| - | |||
| - | {{:arduino_boards:motor_control_board_test.zip|test program}} | ||
| - | |||
| - | ---- | ||
| - | **Components** | ||
| - | * 1 H-Brigh Driver L298 N | ||
| - | * 6 standard LEDs | ||
| - | * 1 elkos 2200µF | ||
| - | * 2 capacitors 100nF | ||
| - | * 8 diodes 1N4007 | ||
| - | * resistors: 2x 2,2kOhm, 2x 220Ohm | ||
| - | * pins and jumper | ||
| - | |||
| - | ---- | ||
| - | |||
| - | ---- | ||