The Paper-USBasp is a Paper-PCB version of an USB in-circuit programmer for Atmel AVR controllers. The board based on the USBasp Board of Thomas Fischl. On the paper version the serial connection (RX and TX) were removed. A jumper for 3.6V was added.

The Paper USBasp can be perfectly combined with the Programming Board for programming AVR chips:

Or certainly it can be used to burn your bootloader on your Paperduino-Uno:

Here: http://www.fundf.net/usbasp/ one find all schematics and manuals for the original USBasp board. They are similar to the paper version of the programmer.

Front:

Back:

Here is a manual for burning the firmware

paper-usbasp_20_pub.xcf.zip

• Atmega8 or Atmega48
• IC socket, 28 pin
• 2 LEDs red, green
• 1 elkos 4,7µF
• 1 capacitors 100nF
• 2 capacitors 22pF
• 2 diodes 1N4007
• 2 z-diodes 3.6V
• resistors: 1x 2,2kOhm, 2x 68Ohm, 1x 10kOhm, 3x 270Ohm
• USB socket
• 10 pin socket
• pins and jumper

The Paper-USBasp was designed by Wolfgang Spahn 2013.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.