The Fabric-Duino is an Arduino clone for fabric. And for connectors one can make small wire eye.

All Paper-Duino version will works as well, but the smaller version is much handier.

fabric-duino_02.zip

01. Iron the printout on fabric:

02. Cut a Copper-Stripe-Board to the right sice:

03. Solder all parts:

The back should looks like that:

For wireing parts like LEDs and switches one need some Conductive Thread and a needle.

One should first burn the bootloader on the chip: Burning the Bootloader
For uploading a scetch one need a Serial to USB board or: The Arduino as a Serial Adapter

• Atmega328
• 1 LED
• voltage converter 7805
• crystal 16MHz
• 1 elkos 100µF
• 4 capacitors 100nF
• 2 capacitors 22pF
• diode 1N4007
• resistors: 1x 330Ohm, 2x 470Ohm, 1x 10kOhm
• push button
• pin headers & sockets
• battery clip

The Fabric-Duino was designed by Wolfgang Spahn 2017.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.