Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
raspberry_boards:paperduinopi_hat [2016/07/17 01:52] admin [Install the Shutdown Button and the LED] |
raspberry_boards:paperduinopi_hat [2020/06/11 22:13] (current) |
||
|---|---|---|---|
| Line 76: | Line 76: | ||
| $ sudo nano /etc/rc.local | $ sudo nano /etc/rc.local | ||
| Write before "exit 0": | Write before "exit 0": | ||
| - | printf "<<<<<<<< PAPER-DUINO-HAT >>>>>>>>\n" | + | printf ">>>>>>>> PAPER-DUINO-HAT 07_2016 http://dernulleffekt.de\n" |
| - | printf "<<<<<<<< 07_2016 http://dernulleffekt.de >>>>>>>>\n" | + | |
| | | ||
| # run reset and shutdown script | # run reset and shutdown script | ||
| - | printf "Starting shutdown aund reset button on GPIO 22\n" | + | printf ">>>>>>>> Starting shutdown aund reset button on GPIO 22\n" |
| /home/pi/paper-duino-pi/shutdownbutton_hat.py & | /home/pi/paper-duino-pi/shutdownbutton_hat.py & | ||
| | | ||
| # blink an LED | # blink an LED | ||
| - | printf "Starting blinking LED on GPIO 27\n" | + | printf ">>>>>>>> Starting blinking LED on GPIO 27\n" |
| /home/pi/paper-duino-pi/blink_hat.py & | /home/pi/paper-duino-pi/blink_hat.py & | ||
| Line 119: | Line 118: | ||
| ---- | ---- | ||
| - | ~~socialite:icon facebook twitter googleplus reddit~~ | + | ==== License ==== |
| + | |||
| + | The Paper-Duino-Hat was designed by **Wolfgang Spahn** 2012-16.\\ | ||
| + | It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]]. | ||
| + | |||
| + | <html> | ||
| + | <a rel="license" href="http://creativecommons.org/licenses/by-nc-sa/4.0/"><img alt="Creative Commons License" style="border-width:0" src="https://i.creativecommons.org/l/by-nc-sa/4.0/88x31.png" /></a> | ||
| + | </html> | ||
| ---- | ---- | ||
| + | |||