Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
arduino_clones:fabric-duino [2016/06/13 19:34] admin |
arduino_clones:fabric-duino [2016/09/12 17:17] admin |
||
---|---|---|---|
Line 7: | Line 7: | ||
01. Iron the printout on fabric:\\ | 01. Iron the printout on fabric:\\ | ||
{{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ | {{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ | ||
- | 02. Cut a Copper-Stripe-Board in the right sice:\\ | + | 02. Cut a Copper-Stripe-Board to the right sice:\\ |
{{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ | {{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ | ||
- | 03. Solder all parts in:\\ | + | 03. Solder all parts:\\ |
{{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ | {{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ | ||
The back should looks like that:\\ | The back should looks like that:\\ | ||
{{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ | {{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ | ||
+ | For wireing parts like LEDs and switches one need some Conductive Thread and a needle.\\ | ||
---- | ---- | ||
- | For uploading a scetch one need the Adappter-Board and a Serial to USB board.\\ | + | For uploading a scetch one need the Adappter-Board and a Serial to USB board like for the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]].\\ |
- | {{:arduino_clones:fabric-duino_upload_194346.jpg?400|}}\\ | + | |
- | ~~socialite:icon facebook twitter googleplus reddit~~ | + | |
---- | ---- | ||
+ | ~~socialite:icon facebook twitter googleplus reddit tumblr~~ | ||
+ | |||
+ | ---- | ||
+ | ~~DISCUSSION~~ |