Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
arduino_clones:bootloader [2014/07/23 15:29] admin |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ---- | ||
- | **Burning the Bootloader** | ||
- | ---- | ||
- | For burning the bootloader on the Paperduino-UNO, or on the Paper-Leonardo you need to connect the following pins on your Paperduino-UNO with your ISP programmer (in-system programmer): | ||
- | * 11 - MOSI | ||
- | * 12 - MISO | ||
- | * 13 - SCK | ||
- | * Reset | ||
- | * Ground | ||
- | * + 5V | ||
- | After connecting the programmer to your computer select in the Arduino IDE in Tools/Programmer your programmer and than klick Tools/Burn Bootloader. | ||
- | |||
- | ---- | ||
- | **With an AVR ISP programmer** | ||
- | |||
- | {{ :arduino_clones:isp_adapter.jpg?direct&300 |}} | ||
- | |||
- | On the foto you see the ISP programmer with an ISP adapter board. But you could also build your own modified wire like that on the [[http://arduino.cc/en/Hacking/MiniBootloader|Mini Bootloader project]]. Anyway here are the connection of an original ISP header. | ||
- | |||
- | {{:arduino_clones:isp-header.jpg?nolink|}} | ||
- | |||
- | Cause my ISP programmer has a different protokoll as the originale AVR-ISP programmer I had to modifie the programmers.txt file.\\ | ||
- | In that folder(on Linux): | ||
- | /usr/share/arduino/hardware/arduino | ||
- | The third line has to change to: | ||
- | avrisp.protocol=stk500v1 | ||
- | |||
- | ---- | ||
- | **With the Paper-USBasp programmer** | ||
- | It is simelar like the AVR ISP programmer, just select the USBasp programmer and burn. | ||
- | Here is the manual for the [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]]. | ||
- | |||
- | ---- | ||
- | **With a Paperduino-UNO** | ||
- | |||
- | The Paperduino-UNO was designed for cloneing and that's why you can use your Paperduino-UNO fot burning bootloder, too. Just load the ArduinoISP - in the examples - on your Paperduino-UNO. After that, **turn off the auto reset by removeing the auto reset jumper**. And than connect the pins like that: | ||
- | * 13 to 13 | ||
- | * 12 to 12 | ||
- | * 11 to 11 | ||
- | * 10 to Reset | ||
- | * Ground to Ground | ||
- | * +5V to +5V | ||
- | ... and than burn! | ||
- | |||
- | {{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}} | ||
- | |||
- | ---- |