Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
arduino_boards:simple_input_shield [2015/10/27 21:58] admin [Input Shield] |
arduino_boards:simple_input_shield [2015/10/27 21:58] admin [Input Shield] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ---- | ---- | ||
| - | A simple shield for the Arduino with two potentiometer and four buttons. It has an power LED and a LED onb pin 13.\\ | + | A simple shield for the Arduino with two potentiometer and four buttons. It has an power LED and a LED on pin 13.\\ |
| - | {{:arduino_boards:input-shield_arduino.jpg?300|}}\\ | + | {{ :arduino_boards:input-shield_arduino.jpg?400 |}}\\ |
| One has to make two cuts through the copperstripes on the protoboard. And after building one has to bend the legs of the second 8pin header so they fit on the Arduino header.\\ | One has to make two cuts through the copperstripes on the protoboard. And after building one has to bend the legs of the second 8pin header so they fit on the Arduino header.\\ | ||
| The butttons are on pin 2,7,8 and 12 and one has to use the internal pullup resistor. The potis are on analog 0 and 1. | The butttons are on pin 2,7,8 and 12 and one has to use the internal pullup resistor. The potis are on analog 0 and 1. | ||