Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
raspberry_boards:raspberry_io_board [2014/07/23 15:35] admin |
raspberry_boards:raspberry_io_board [2015/10/22 15:42] admin |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ---- | ---- | ||
| - | **Raspberry In Output Board** | + | ==== Raspberry In Output Board ==== |
| ---- | ---- | ||
| Line 11: | Line 11: | ||
| For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] | For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] | ||
| - | |||
| - | ---- | ||
| - | **Technical documentation** | ||
| The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. | The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. | ||
| Line 22: | Line 19: | ||
| ---- | ---- | ||
| - | **Paper-PCB** | + | ==== Paper-PCB ==== |
| {{:raspberry_boards:raspberry_in_output_board_11.jpg?100|}} | {{:raspberry_boards:raspberry_in_output_board_11.jpg?100|}} | ||
| Line 29: | Line 26: | ||
| ---- | ---- | ||
| - | **Components** | + | ==== Parts ==== |
| * 2x 26 pin female Ribbon Socket Connector | * 2x 26 pin female Ribbon Socket Connector | ||
| * 26 pin male Shrouded Box Header | * 26 pin male Shrouded Box Header | ||