Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
raspberry_boards:raspberry_basic_hat [2017/09/12 18:12] admin [Install the Shutdown Button and the LED] |
raspberry_boards:raspberry_basic_hat [2017/09/12 19:21] admin [Paper-Duino-Hat] |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Paper-Duino-Hat ===== | ===== Paper-Duino-Hat ===== | ||
+ | {{:raspberry_boards:raspberry_basic_hat.jpg?600|}}\\ | ||
That's the pure reduced simple Basic Hat for the Raspberry Pi. If one just needs a reset button, a control LED and a switch, that is the right board.\\ | That's the pure reduced simple Basic Hat for the Raspberry Pi. If one just needs a reset button, a control LED and a switch, that is the right board.\\ | ||
- | It has an Reset-Button (GPIO 22) and a GPIO LED (GPIO 27). | + | It has an Reset-Button (GPIO 22) and a GPIO LED (GPIO 27). On GPIO 18 is a switch. |
---- | ---- | ||
- | |||
==== Paper PCB ==== | ==== Paper PCB ==== | ||
+ | {{:raspberry_boards:raspberry_basic_hat_02.jpg?600|}}\\ | ||
+ | {{ :raspberry_boards:raspberry_basic_hat_02.zip |}} | ||
---- | ---- | ||
Line 39: | Line 41: | ||
# run reset and shutdown script | # run reset and shutdown script | ||
printf ">>>>>>>> Starting shutdown aund reset button on GPIO 22\n" | printf ">>>>>>>> Starting shutdown aund reset button on GPIO 22\n" | ||
- | /home/pi/paper-duino-pi/shutdownbutton_hat.py & | + | /home/pi/basic-hat/shutdownbutton_hat.py & |
| | ||
# blink an LED | # blink an LED | ||
printf ">>>>>>>> Starting blinking LED on GPIO 27\n" | printf ">>>>>>>> Starting blinking LED on GPIO 27\n" | ||
- | /home/pi/paper-duino-pi/blink_hat.py & | + | /home/pi/basic-hat/blink_hat.py & |
To save and leave press: CTRL+O, Enter, CTRL+X\\ | To save and leave press: CTRL+O, Enter, CTRL+X\\ |