This is an old revision of the document!
Paper USBasp
That board based on the USBasp Board of Thomas Fischl. On the paper version the serial connection (RX and TX) were removed. A jumper for 3.6V was added.
The Paper USBasp can be perfectly combined with the Programming Board for programming AVR chips:
Or certainly it can be used to burn your bootloader on your Paperduino-Uno:
On http://www.fundf.net/usbasp/ one find all schematics and manuals for the original USBasp board. They are similar to the paper version.
Front:
Back:
Paper-PCB
Components
- Atmega8 or Atmega48
- IC socket, 28 pin
- 2 LEDs red, green
- 1 elkos 4,7µF
- 1 capacitors 100nF
- 2 capacitors 22pF
- 2 diodes 1N4007
- 2 z-diodes 3.6V
- resistors: 1x 2,2kOhm, 2x 68Ohm, 1x 10kOhm, 3x 270Ohm
- USB socket
- 10 pin socket
- pins and jumper