This is an old revision of the document!
== Paper USBasp ==========================================
That board based on the USBasp Board of Thomas Fischl.
On the paper version the serial connection (RX and TX) were removed. A jumper for 3.6V was added.
The Paper USBasp can be perfectly combined with the Programming Board:
Or certainly can be used to burn your bootloader on the Paperduino-Uno:
On http://www.fundf.net/usbasp/ one find all schematics and manuals for the original USBasp board. They are similare to the paper version.
== Paper-PCB ============================================
paper-usbasp_20_pub.xcf.zip
== Components ===========================================
- Atmega8 or Atmega48
- IC socket, 28 pin
- 2 LEDs red, green
- 1 elkos 4,7µF
- 1 capacitors 100nF
- 2 capacitors 22pF
- 2 diodes 1N4007
- 2 z-diodes 3.6V
- resistors: 1x 2,2kOhm, 2x 68Ohm, 1x 10kOhm, 3x 270Ohm
- USB socket
- 10 pin socket
- pins and jumper
===========================================================