This is an old revision of the document!

== Paper USBasp ==========================================

That board based on the USBasp Board of Thomas Fischl. There one find all schematics and manuals for the board.
On the paper version the serial connection (RX and TX) were removed. A jumper for 3.6V was added.

The Paper USBasp can be perfectly combined with the Programming Board:

Or just be used to burn your bootloader on the Paperduino-Uno:

== Paper-PCB ============================================

paper-usbasp_20_pub.xcf.zip

== Components ===========================================

• Atmega8 or Atmega48
• IC socket, 28 pin
• 2 LEDs red, green
• 1 elkos 4,7µF
• 1 capacitors 100nF
• 2 capacitors 22pF
• 2 diodes 1N4007
• 2 z-diodes 3.6V
• resistors: 1x 2,2kOhm, 2x 68Ohm, 1x 10kOhm, 3x 270Ohm
• USB socket
• 10 pin socket
• pins and jumper

===========================================================