Differences
This shows you the differences between two versions of the page.
|
avr_bootloader:paper_usbasp [2013/03/22 23:42] admin |
avr_bootloader:paper_usbasp [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | **== Paper USBasp ==========================================** | ||
| - | That board based on the [[http://www.fischl.de/usbasp/|USBasp Board]] of [[http://www.fischl.de|Thomas Fischl]]. There one find all schematics and manuals for the board.\\ | ||
| - | On the paper version the serial connection (RX and TX) were removed. A jumper for 3.6V was added.\\ | ||
| - | |||
| - | {{ :avr_bootloader:paper_usbasp_-_programmer_board_1265.jpg?300 |}} | ||
| - | The Paper USBasp can be perfectly combined with the [[avr_bootloader:programming_board|Programming Board]]. | ||
| - | {{ :avr_bootloader:paper_usbasp_1274.jpg?300 |}}\\ | ||
| - | Or just be used to burn your bootloader on the [[arduino_clones:paperduino-uno|Paperduino-Uno]]. | ||
| - | |||
| - | {{:avr_bootloader:paper_usbasp_front_1266.jpg?200|}}\\ | ||
| - | {{:avr_bootloader:paper_usbasp_back_1267.jpg?200|}}\\ | ||
| - | |||
| - | |||
| - | |||
| - | **== Paper-PCB ============================================** | ||
| - | {{:avr_bootloader:paper-usbasp_20_pub_stripes.jpg?200|}}\\ | ||
| - | {{:avr_bootloader:paper-usbasp_20_pub.jpg?200|}}\\ | ||
| - | {{:avr_bootloader:paper-usbasp_20_pub.xcf.zip|}}\\ | ||
| - | |||
| - | **== Components ===========================================** | ||
| - | |||
| - | * Atmega8 or Atmega48 | ||
| - | * IC socket, 28 pin | ||
| - | * 2 LEDs red, green | ||
| - | * 1 elkos 4,7µF | ||
| - | * 1 capacitors 100nF | ||
| - | * 2 capacitors 22pF | ||
| - | * 2 diodes 1N4007 | ||
| - | * 2 z-diodes 3.6V | ||
| - | * resistors: 1x 2,2kOhm, 2x 68Ohm, 1x 10kOhm, 3x 270Ohm | ||
| - | * USB socket | ||
| - | * 10 pin socket | ||
| - | * pins and jumper | ||
| - | |||
| - | **===========================================================** | ||