Differences
This shows you the differences between two versions of the page.
|
arduino_clones:serial_adapter [2014/07/23 15:18] admin |
arduino_clones:serial_adapter [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ---- | ||
| - | **Arduino as Serial Adapter** | ||
| - | ---- | ||
| - | If you don't have any USB to Serial adapter you can use your Arduino for that (Arduino-Uno or older). After removeing the chip on the board connect the pins like seen on the picture: | ||
| - | * +5V to +5V | ||
| - | * Ground to Ground | ||
| - | * Pin1 to DTR | ||
| - | * RX to RX | ||
| - | * TX to TX | ||
| - | |||
| - | {{ :arduino_clones:arduino_as_serial_to_usb_adapter_wspahn.jpg?direct&450 |}} | ||
| - | |||
| - | ---- | ||