Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
arduino_clones:papercocomake1 [2018/05/11 18:16] admin [Parts] |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== PaperCocoMake1 ===== | ||
| - | The PaperCocoMake1 in an Arduino board based on Paper PCB and an ATtiny85 chip. It is the paper version of the CocoMake1.\\ | ||
| - | For code and the Arduino IDE mod please follow the [[https://cocomake7.github.io/#|CocoMake7]] webside.\\ | ||
| - | Here you find the [[arduino_clones:papercocomake7|PaperCocoMake7]] and the [[arduino_clones:papertiny|PaperTiny]].\\ | ||
| - | |||
| - | {{:arduino_clones:papercocomake1.jpg|}}\\ | ||
| - | ---- | ||
| - | ==== Paper PCB ==== | ||
| - | {{:arduino_clones:papercocomake1_10.jpg?200|}}\\ | ||
| - | {{ :arduino_clones:papercocomake1_10.zip |}}\\ | ||
| - | |||
| - | ---- | ||
| - | ==== schematic ==== | ||
| - | It's the one from [[https://cocomake7.github.io/#]], I just used 2k resistors for the LED resistors and added a power supply.\\ | ||
| - | {{:arduino_clones:mrbaladuinoone_schematic.png?400|}}\\ | ||
| - | |||
| - | ---- | ||
| - | ==== Parts ==== | ||
| - | * **Resistors:** | ||
| - | * 2x 2 kOhm | ||
| - | * 1x 1,5 kOhm | ||
| - | * 2x 68 Ohm | ||
| - | * **Capacitors:** | ||
| - | * 1x 100 nF | ||
| - | * 1x 100 µF | ||
| - | * **Diodes:** | ||
| - | * 1x 1N4007 | ||
| - | * 2x Z-Diode 3,3V | ||
| - | * **Semiconductors** | ||
| - | * 1x7805 | ||
| - | * 2x Standart LED | ||
| - | * **Mechanical:** | ||
| - | * 1x IC socket, 8pins | ||
| - | * 1x Pin-Strip male 1x2 | ||
| - | * 2x Pin-Strip female 1x4 | ||
| - | |||
| - | |||
| - | ---- | ||