This is an old revision of the document!
Fabric-Duino
The Fabric-Duino is an Arduino clone for fabric. And for connectors one can make small wire eye.
All Paper-Duino version will works as well, but the smaller version is much handier.
Paper PCB
01. Iron the printout on fabric:
02. Cut a Copper-Stripe-Board to the right sice:
03. Solder all parts:
The back should looks like that:
For wireing parts like LEDs and switches one need some Conductive Thread and a needle.
For uploading a scetch one need the Adappter-Board and a Serial to USB board like for the Paper-Duino-Mini.
~~socialite:icon facebook twitter googleplus reddit tumblr~~
~~DISCUSSION~~