Differences
This shows you the differences between two versions of the page.
arduino_clones:fabric-duino [2016/06/13 19:36] admin |
arduino_clones:fabric-duino [2020/06/11 22:13] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Fabric-Duino ===== | ||
- | {{ :arduino_clones:fabric-duino_011229.jpg?400 |}}\\ | ||
- | The Fabric-Duino is basically a version of the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]]. One use fabric instead of the paper. And as connector one make small wire eye.\\ | ||
- | {{ :arduino_clones:duino-shirt.jpg?400 |}}\\ | ||
- | The Paper-Duino-UNO works as well, but the smaller version is much handier.\\ | ||
- | 01. Iron the printout on fabric:\\ | ||
- | {{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ | ||
- | 02. Cut a Copper-Stripe-Board to the right sice:\\ | ||
- | {{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ | ||
- | 03. Solder all parts:\\ | ||
- | {{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ | ||
- | The back should looks like that:\\ | ||
- | {{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ | ||
- | For wireing parts like LEDs and switches one need some Conductive Thread and a needle.\\ | ||
- | |||
- | ---- | ||
- | For uploading a scetch one need the Adappter-Board and a Serial to USB board.\\ | ||
- | {{:arduino_clones:fabric-duino_upload_194346.jpg?400|}}\\ | ||
- | ~~socialite:icon facebook twitter googleplus reddit~~ | ||
- | |||
- | ---- |