Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
arduino_clones:bootloader [2012/09/23 20:48] admin |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | **== Burning the Bootloader ==============================** | ||
- | For burning the bootloader you need to connect these pins on your Paperduino-UNO with the programmer: | ||
- | * 11 - MOSI | ||
- | * 12 - MISO | ||
- | * 13 - SCK | ||
- | * Reset | ||
- | * Ground | ||
- | * + 5V | ||
- | |||
- | **Burning the bootloader with an AVR programmer:**\\ | ||
- | Cause my ISP programmer (in-system programmer) has a different protokoll as the originale AVR-ISP programmer I had to modifie the file "programmers.txt" in that folder:\\ | ||
- | /usr/share/arduino/hardware/arduino.\\ | ||
- | The third line has to change to:\\ | ||
- | "avrisp.protocol=stk500v1".\\ | ||
- | On the foto you see the ISP programmer with an ISP adapter board. | ||
- | |||
- | {{ :arduino_clones:isp-header.jpg?nolink&100 |}}These are the connection of an original ISP header. | ||
- | |||
- | {{ :arduino_clones:isp_adapter.jpg?direct&300 |}} | ||
- | |||
- | ** Burning the bootoloader with an Arduino**\\ | ||
- | You can use your Arduino to burn the bootloder. Just load the ArduinoISP (in examples) on your Arduino. Connect the pins like that: | ||
- | |||
- | |||
- | |||
- | |||
- | {{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}} | ||
- | |||
- | **===========================================================** |