Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
arduino_clones:bootloader [2014/07/23 15:31] admin |
arduino_clones:bootloader [2015/10/17 13:31] admin removed |
||
---|---|---|---|
Line 1: | Line 1: | ||
---- | ---- | ||
- | **Burning the Bootloader** | + | **Burning the Bootloader with the Arduino IDE** |
---- | ---- | ||
Line 26: | Line 26: | ||
The third line has to change to: | The third line has to change to: | ||
avrisp.protocol=stk500v1 | avrisp.protocol=stk500v1 | ||
+ | |||
---- | ---- | ||
Line 35: | Line 36: | ||
Here is a manual for building your own [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]]. | Here is a manual for building your own [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]]. | ||
+ | |||
---- | ---- | ||
Line 49: | Line 51: | ||
{{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}} | {{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}} | ||
+ | |||
+ | ---- | ||
+ | ** Burning the Bootloader with the AVRdude** | ||
+ | |||
+ | Burning the bootloader on an Atmega328p chip of | ||
+ | a Paperduino-Uno or a Paper-Duino-Pi with an AVR ISP programmer. | ||
+ | |||
+ | Go to the folder with the bootloader. | ||
+ | |||
+ | Run avrdude in command line: | ||
+ | $ sudo avrdude -p m328p -c stk500v2 -P /dev/ttyACM0 -U flash:w:optiboot_atmega328.hex:i | ||
+ | | ||
+ | More at the [[arduino_clones:AVRdude|AVRdude]] page. | ||
---- | ---- |