Differences

This shows you the differences between two versions of the page.

--- arduino_clones:bootloader [2014/07/23 15:29]
admin
+++ arduino_clones:bootloader [2015/10/17 13:31]
admin removed
@@ Line 1: / Line 1: @@
 ----
-**Burning the Bootloader**
+**Burning the Bootloader with the Arduino IDE**
 ----
@@ Line 26: / Line 26: @@
 The third line has to change to:
   avrisp.protocol=stk500v1
 ----
 **With the Paper-USBasp programmer**
-It is simelar like the AVR ISP programmer, just select the USBasp programmer and burn.
-Here is the manual for the [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]].
+It is simelar to the AVR ISP programmer, just select the USBasp programmer and burn.
+{{ :avr_bootloader:paper_usbasp_1274.jpg?300 |}}
+Here is a manual for building your own [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]].
 ----
@@ Line 45: / Line 51: @@
 {{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}}
+----
+** Burning the Bootloader with the AVRdude**
+Burning the bootloader on an Atmega328p chip of
+a Paperduino-Uno or a Paper-Duino-Pi with an AVR ISP programmer.
+Go to the folder with the bootloader.
+Run avrdude in command line:
+  $ sudo avrdude -p m328p -c stk500v2 -P /dev/ttyACM0 -U flash:w:optiboot_atmega328.hex:i
+More at the [[arduino_clones:AVRdude|AVRdude]] page.
 ----

Paper-PCBs