This is an old revision of the document!

== Burning the Bootloader ==============================

For burning the bootloader you need to connect these pins on your Paperduino-UNO with the programmer:

• 11 - MOSI
• 12 - MISO
• 13 - SCK
• Reset
• Ground
• + 5V

Burning the bootloader with an AVR programmer:
Cause the programmer has a different protokoll to the originale AVR-ISP programmer I had to modifie the file “programmers.txt” in /usr/share/arduino/hardware/arduino. The third line has to change to.
“avrisp.protocol=stk500v1”.
On the foto you see a cheap ISP programmer (in-system programmer) with an ISP adapter board.

These are the connection of an original ISP header.

Burning the bootoloader with an Arduino
You can use your Arduino to burn the bootloder. Just load the ArduinoISP (in examples) on your Arduino. Connect the pins like that:

===========================================================