Differences
This shows you the differences between two versions of the page.
|
arduino_boards:motor_control_board [2013/03/21 23:52] admin |
arduino_boards:motor_control_board [2020/06/11 22:13] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | **== Motor Control Board ===================================** | ||
| - | |||
| - | [[http://dernulleffekt.de/motorcontroller.html|Motor-Control-Board]] | ||
| - | |||
| - | **== Simple-Input-Board ===================================** | ||
| - | |||
| - | This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports. | ||
| - | - Forward:...ON - OFF | ||
| - | - Stop:......OFF - OFF | ||
| - | - Backward:..OFF - ON | ||
| - | Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.\\ | ||
| - | With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino. | ||
| - | {{ :arduino_boards:motor_control_board_02.jpg?300 |}}\\ | ||
| - | {{ :arduino_boards:motor_control_board-back_1263.jpg?300 |}}\\ | ||
| - | |||
| - | **== Paper-PCB ============================================** | ||
| - | {{:arduino_boards:motor_control_board_21_pub.jpg?200|}} | ||
| - | |||
| - | |||
| - | **== Components ===========================================** | ||
| - | |||
| - | * 1 H-Brigh Driver L298 N | ||
| - | * 6 standard LEDs | ||
| - | * 1 elkos 2200µF | ||
| - | * 2 capacitors 100nF | ||
| - | * 8 diodes 1N4007 | ||
| - | * resistors: 2x 2,2kOhm, 2x 220Ohm | ||
| - | * Jumper | ||
| - | |||
| - | **=========================================================** | ||
| - | |||