Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
about:smd-soldering [2014/07/15 20:41] admin |
about:smd-soldering [2020/06/11 22:13] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ---- | ---- | ||
| - | **SMD Solder Manual** | + | ==== SMD Solder Manual ==== |
| ---- | ---- | ||
| - | For SMD soldering one needs rosin (also called colophony). It helps the molten metal to flow and makes a better connection. Use it with alcohol and a brush. | + | For SMD soldering one needs rosin (also called colophony). It helps the molten metal to flow and makes a better connection. Use it with alcohol and a brush.\\ |
| - | Because SMDs are super small a magnifying glass could help a lot, too.\\ | + | Because SMDs are super small a magnifying glass could do magic, too.\\ |
| {{ :about:smd-loeten_00.jpg?300 |}}\\ | {{ :about:smd-loeten_00.jpg?300 |}}\\ | ||
| And certainly one needs a normal solder iron and all the standart tools for soldering.\\ | And certainly one needs a normal solder iron and all the standart tools for soldering.\\ | ||
| Line 24: | Line 24: | ||
| 8. Solder one leg without any extra solder, just melt the one on the pads. Check if the possition is OK, than solder all the other pins, again no solder is needed.\\ | 8. Solder one leg without any extra solder, just melt the one on the pads. Check if the possition is OK, than solder all the other pins, again no solder is needed.\\ | ||
| {{:about:smd-loeten_08.jpg?200|}}\\ | {{:about:smd-loeten_08.jpg?200|}}\\ | ||
| - | 9. Check all pins for bridges. If there is one desolder it with a desoldering braid.\\ | + | 9. Check all connections and the pins for bridges. If there is one desolder it with a desoldering braid.\\ |
| {{:about:smd-loeten_09.jpg?200|}}\\ | {{:about:smd-loeten_09.jpg?200|}}\\ | ||
| 10. Solder some proper pins on the board, too.\\ | 10. Solder some proper pins on the board, too.\\ | ||