Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
arduino_clones:bootloader [2014/07/23 15:32] admin |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ---- | ||
| - | **Burning the Bootloader** | ||
| - | ---- | ||
| - | For burning the bootloader on the Paperduino-UNO, or on the Paper-Leonardo you need to connect the following pins on your Paperduino-UNO with your ISP programmer (in-system programmer): | ||
| - | * 11 - MOSI | ||
| - | * 12 - MISO | ||
| - | * 13 - SCK | ||
| - | * Reset | ||
| - | * Ground | ||
| - | * + 5V | ||
| - | After connecting the programmer to your computer select in the Arduino IDE in Tools/Programmer your programmer and than klick Tools/Burn Bootloader. | ||
| - | |||
| - | ---- | ||
| - | **With an AVR ISP programmer** | ||
| - | |||
| - | {{ :arduino_clones:isp_adapter.jpg?direct&300 |}} | ||
| - | |||
| - | On the foto you see the ISP programmer with an ISP adapter board. But you could also build your own modified wire like that on the [[http://arduino.cc/en/Hacking/MiniBootloader|Mini Bootloader project]]. Anyway here are the connection of an original ISP header. | ||
| - | |||
| - | {{:arduino_clones:isp-header.jpg?nolink|}} | ||
| - | |||
| - | Cause my ISP programmer has a different protokoll as the originale AVR-ISP programmer I had to modifie the programmers.txt file.\\ | ||
| - | In that folder(on Linux): | ||
| - | /usr/share/arduino/hardware/arduino | ||
| - | The third line has to change to: | ||
| - | avrisp.protocol=stk500v1 | ||
| - | |||
| - | |||
| - | ---- | ||
| - | **With the Paper-USBasp programmer** | ||
| - | |||
| - | It is simelar to the AVR ISP programmer, just select the USBasp programmer and burn. | ||
| - | |||
| - | {{ :avr_bootloader:paper_usbasp_1274.jpg?300 |}} | ||
| - | |||
| - | Here is a manual for building your own [[avr_bootloader:paper_usbasp|Paper-USBasp programmmer]]. | ||
| - | |||
| - | |||
| - | ---- | ||
| - | **With a Paperduino-UNO** | ||
| - | |||
| - | The Paperduino-UNO was designed for cloneing and that's why you can use your Paperduino-UNO fot burning bootloder, too. Just load the ArduinoISP - in the examples - on your Paperduino-UNO. After that, **turn off the auto reset by removeing the auto reset jumper**. And than connect the pins like that: | ||
| - | * 13 to 13 | ||
| - | * 12 to 12 | ||
| - | * 11 to 11 | ||
| - | * 10 to Reset | ||
| - | * Ground to Ground | ||
| - | * +5V to +5V | ||
| - | ... and than burn! | ||
| - | |||
| - | {{ :arduino_clones:paperduino-uno_as_isp_adapter_wspahn.jpg?direct&300 |}} | ||
| - | |||
| - | ---- | ||