Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
about:how_to [2012/06/09 14:29] admin created |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | **==========================================================**\\ | ||
| - | You need: | ||
| - | * protoboard | ||
| - | * printer | ||
| - | * transparent paper | ||
| - | * double sided tape | ||
| - | * needle | ||
| - | * cutter | ||
| - | |||
| - | - Print out the drawn circuit on transparent paper; | ||
| - | - Glue a doublesided tape on the back of the print; | ||
| - | - Stick the printed trasparent paper on the protoboard, care about the marks; | ||
| - | - Pierce all marked holes with a needle; | ||
| - | - Remove the copperstripes under the chip (if it's a board with chips); | ||
| - | - Cut off exess material; … and now, start to solder! | ||
| - | |||
| - | **==========================================================** | ||