Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
raspberry_boards:paperduinopi_hat [2016/07/17 01:50] admin [Install the Shutdown Button and the LED] |
raspberry_boards:paperduinopi_hat [2016/07/17 02:00] admin [Install the Shutdown Button and the LED] |
||
---|---|---|---|
Line 76: | Line 76: | ||
$ sudo nano /etc/rc.local | $ sudo nano /etc/rc.local | ||
Write before "exit 0": | Write before "exit 0": | ||
- | printf "<<<<<<< PAPER-DUINO-HAT >>>>>>>\n" | + | printf "<<<<<<<< PAPER-DUINO-HAT 07_2016 http://dernulleffekt.de\n" |
- | printf "<<<<<<< 07_2016 http://dernulleffekt.de >>>>>>>\n" | + | |
- | # run reset and shutdown script | + | # run reset and shutdown script |
- | printf "Starts shutdown aund reset button on GPIO 22\n" | + | printf "<<<<<<<< Starting shutdown aund reset button on GPIO 22\n" |
- | /home/pi/paper-duino-pi/shutdownbutton_hat.py & | + | /home/pi/paper-duino-pi/shutdownbutton_hat.py & |
- | # blink an LED | + | |
- | printf "Starts blinking LED on GPIO 27\n" | + | # blink an LED |
- | /home/pi/paper-duino-pi/blink_hat.py & | + | printf "<<<<<<<< Starting blinking LED on GPIO 27\n" |
+ | /home/pi/paper-duino-pi/blink_hat.py & | ||
To save and leave press: CTRL+O, Enter, CTRL+X\\ | To save and leave press: CTRL+O, Enter, CTRL+X\\ | ||
Reboot: | Reboot: |