Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
raspberry_boards:paperduinopi_hat [2016/07/17 01:08] admin [Installing the Arduino IDE] |
raspberry_boards:paperduinopi_hat [2016/09/12 17:23] admin |
||
|---|---|---|---|
| Line 76: | Line 76: | ||
| $ sudo nano /etc/rc.local | $ sudo nano /etc/rc.local | ||
| Write before "exit 0": | Write before "exit 0": | ||
| - | # run reset and shutdown script | + | printf ">>>>>>>> PAPER-DUINO-HAT 07_2016 http://dernulleffekt.de\n" |
| - | printf "Starts shutdown aund reset button on GPIO 22\n" | + | |
| - | /home/pi/paper-duino-pi/shutdownbutton_hat.py & | + | # run reset and shutdown script |
| - | # blink an LED | + | printf ">>>>>>>> Starting shutdown aund reset button on GPIO 22\n" |
| - | printf "Starts blinking LED on GPIO 27\n" | + | /home/pi/paper-duino-pi/shutdownbutton_hat.py & |
| - | /home/pi/paper-duino-pi/blink_hat.py & | + | |
| + | # blink an LED | ||
| + | printf ">>>>>>>> Starting blinking LED on GPIO 27\n" | ||
| + | /home/pi/paper-duino-pi/blink_hat.py & | ||
| To save and leave press: CTRL+O, Enter, CTRL+X\\ | To save and leave press: CTRL+O, Enter, CTRL+X\\ | ||
| Reboot: | Reboot: | ||
| Line 114: | Line 118: | ||
| ---- | ---- | ||
| - | ~~socialite:icon facebook twitter googleplus reddit~~ | + | ~~socialite:icon facebook twitter googleplus reddit tumblr~~ |
| ---- | ---- | ||
| + | ~~DISCUSSION~~ | ||