Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
raspberry_boards:embedded_artist_board [2015/10/15 17:19] admin |
raspberry_boards:embedded_artist_board [2015/10/22 15:22] admin [Paper-PCB] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ---- | ---- | ||
| - | Embedded Artist Board | + | ==== Embedded Artist Board ==== |
| ---- | ---- | ||
| A multi purpose board for the Raspberry Pi it is used for the Embedded Artist Devices: [[http://www.embedded-artist.net/doku.php]]. | A multi purpose board for the Raspberry Pi it is used for the Embedded Artist Devices: [[http://www.embedded-artist.net/doku.php]]. | ||
| + | It's based on the [[raspberry_boards:paperduinopi|Paper-Duino-Pi]]. I has two MOS Fet for driving loads and an H-Bridge for two motors. In the Embedded Art System we attached two servo motors, too. | ||
| + | |||
| + | The board was ment to be controlled with a Python program on the Raspberry Pi and a kind of firmware on the Paper-Duino. | ||
| + | |||
| {{ :raspberry_boards:embeddedartsitboard_124847.jpg?470 |}} | {{ :raspberry_boards:embeddedartsitboard_124847.jpg?470 |}} | ||
| + | |||
| + | ---- | ||
| + | ==== Paper-PCB ==== | ||
| + | |||
| + | {{:raspberry_boards:embeddedart-board_13.jpg?200|}}\\ | ||
| + | {{:raspberry_boards:embeddedart-board_13.xcf.zip|}}\\ | ||
| + | |||
| + | ----- | ||
| + | ==== Knowledge ==== | ||
| GPIO:\\ | GPIO:\\ | ||
| + | [[http://elinux.org/Rpi_Low-level_peripherals]]\\ | ||
| <html> | <html> | ||
| - | <scr=http://elinux.org/File:Pi-GPIO-header-26-sm.png> | + | <img src="http://elinux.org/images/8/80/Pi-GPIO-header-26-sm.png" width=300 alt=""> |
| </html> | </html> | ||
| - | [[http://elinux.org/Rpi_Low-level_peripherals]] | + | |