Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
paper_bits:pb204_sync-sequencer [2020/03/20 22:01] admin [Manual] |
paper_bits:pb204_sync-sequencer [2020/03/21 10:47] admin [Software] |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| === Change the Speed === | === Change the Speed === | ||
| - | The speed can be set withe the SPEED potentiometer or with an external control voltage. For the external control the Ex-Speed switch has to be on ON and with a jumper one can choose if the voltage source coming from BUS 1 or BUS 2.\\ | + | The speed of the sequencer can be changed with the SPEED potentiometer or with an external control voltage. For the external control the EX-SPEED switch has to be on ON and with a jumper one can choose if the voltage source coming from BUS 1 or BUS 2.\\ |
| If the Sequencer is in the **STEP 1 MODE** one can change the active steps with the control voltage, too.\\ | If the Sequencer is in the **STEP 1 MODE** one can change the active steps with the control voltage, too.\\ | ||
| === External Trigger === | === External Trigger === | ||
| - | If one wants to use an external trigger signal one has to set the Ex-Trigger switch on ON. If the TRIGGER jumper is set the trigger signal will come over the Gate BUS. If the jumper is not set then one can use the pin marked with IN for a trigger signal input.\\ | + | If one wants to use an external trigger signal one has to set the Ex-Trigger switch on ON. If the TRIGGER jumper is set the trigger signal will come from the GATE BUS. If the jumper is not set then one can use the pin marked with IN for a trigger signal input.\\ |
| ---- | ---- | ||
| Line 73: | Line 73: | ||
| [[https://www.arduino.cc/en/Guide/ArduinoProMini|more about arduino pro mini]]\\ | [[https://www.arduino.cc/en/Guide/ArduinoProMini|more about arduino pro mini]]\\ | ||
| Or use your Arduino for that:\\ | Or use your Arduino for that:\\ | ||
| - | [[http://paperpcb.dernulleffekt.de/doku.php?id=arduino_clones:serial_adapter]]\\ | + | [[http://paperpcb.dernulleffekt.de/doku.php?id=arduino_clones:serial_adapter|Serial Adapter Board]]\\ |
| Open the Arduino IDE software on your computer and upload the following code to the board: | Open the Arduino IDE software on your computer and upload the following code to the board: | ||