Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
arduino_clones:papertiny [2018/05/25 19:29] admin [Links & Knowledge] |
arduino_clones:papertiny [2018/05/29 15:02] admin [Firmware] |
||
---|---|---|---|
Line 20: | Line 20: | ||
===Burn The Adafruit Bootloader=== | ===Burn The Adafruit Bootloader=== | ||
Download the bootloader from here: [[https://github.com/adafruit/Adafruit-Trinket-Gemma-Bootloader]], unpack it and cd to the folder.\\ | Download the bootloader from here: [[https://github.com/adafruit/Adafruit-Trinket-Gemma-Bootloader]], unpack it and cd to the folder.\\ | ||
+ | On Debian together with Arduin 1.8.5 use the old 2.01 version of the bootloader: [[https://github.com/micronucleus/micronucleus/releases/tag/v2.01]]\\ | ||
$ cd to_your_folder.../Adafruit\ Trinket/Adafruit-Trinket-Gemma-Bootloader-master/ | $ cd to_your_folder.../Adafruit\ Trinket/Adafruit-Trinket-Gemma-Bootloader-master/ | ||
With an AVR Programmer or a Paperduino [[avr_bootloader:bootloader|burn the bootloader]]. Connect the SCK, MISO, MOSI, Reset, GND and +5V pins. If the avrdude is installed run the following commands in your terminal.\\ | With an AVR Programmer or a Paperduino [[avr_bootloader:bootloader|burn the bootloader]]. Connect the SCK, MISO, MOSI, Reset, GND and +5V pins. If the avrdude is installed run the following commands in your terminal.\\ | ||
Line 48: | Line 49: | ||
or the instruction of the Adafruit Trinket board:\\ | or the instruction of the Adafruit Trinket board:\\ | ||
[[https://learn.adafruit.com/introducing-trinket/introduction]]\\ | [[https://learn.adafruit.com/introducing-trinket/introduction]]\\ | ||
+ | **Select the "Adafruit Trinket 8MHz" board from Tools/Board and "USBtinyISP" from Tools/Programmer.** | ||
---- | ---- | ||
==== Schematic ==== | ==== Schematic ==== |