Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
arduino_clones:fabric-duino [2016/06/13 19:13] admin created |
arduino_clones:fabric-duino [2016/09/12 17:17] admin |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Fabric-Duino ===== | ===== Fabric-Duino ===== | ||
| + | {{ :arduino_clones:fabric-duino_011229.jpg?400 |}}\\ | ||
| The Fabric-Duino is basically a version of the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]]. One use fabric instead of the paper. And as connector one make small wire eye.\\ | The Fabric-Duino is basically a version of the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]]. One use fabric instead of the paper. And as connector one make small wire eye.\\ | ||
| + | |||
| + | {{ :arduino_clones:duino-shirt.jpg?400 |}}\\ | ||
| + | The Paper-Duino-UNO works as well, but the smaller version is much handier.\\ | ||
| + | 01. Iron the printout on fabric:\\ | ||
| + | {{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ | ||
| + | 02. Cut a Copper-Stripe-Board to the right sice:\\ | ||
| + | {{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ | ||
| + | 03. Solder all parts:\\ | ||
| + | {{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ | ||
| + | The back should looks like that:\\ | ||
| + | {{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ | ||
| + | For wireing parts like LEDs and switches one need some Conductive Thread and a needle.\\ | ||
| + | |||
| + | ---- | ||
| + | For uploading a scetch one need the Adappter-Board and a Serial to USB board like for the [[arduino_clones:paper-duino-mini|Paper-Duino-Mini]].\\ | ||
| + | |||
| + | ---- | ||
| + | ~~socialite:icon facebook twitter googleplus reddit tumblr~~ | ||
| ---- | ---- | ||
| + | ~~DISCUSSION~~ | ||