Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
arduino_boards:motor_control_board [2013/03/21 23:52] admin |
arduino_boards:motor_control_board [2014/07/23 15:43] admin |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | **== Motor Control Board ===================================** | + | ---- |
+ | **Motor Control Board** | ||
+ | ---- | ||
- | [[http://dernulleffekt.de/motorcontroller.html|Motor-Control-Board]] | + | This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports.\\ |
- | + | - Forward: ON - OFF\\ | |
- | **== Simple-Input-Board ===================================** | + | - Stop: OFF - OFF\\ |
- | + | - Backward: OFF - ON\\ | |
- | This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports. | + | |
- | - Forward:...ON - OFF | + | |
- | - Stop:......OFF - OFF | + | |
- | - Backward:..OFF - ON | + | |
Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.\\ | Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.\\ | ||
With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino. | With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino. | ||
Line 14: | Line 12: | ||
{{ :arduino_boards:motor_control_board-back_1263.jpg?300 |}}\\ | {{ :arduino_boards:motor_control_board-back_1263.jpg?300 |}}\\ | ||
- | **== Paper-PCB ============================================** | + | ---- |
- | {{:arduino_boards:motor_control_board_21_pub.jpg?200|}} | + | **Paper-PCB** |
+ | {{:arduino_boards:motor_control_board_21_pub.jpg?100|}}\\ | ||
+ | {{:arduino_boards:motor_control_board_21.xcf.zip|}} | ||
- | **== Components ===========================================** | + | ---- |
+ | **Code** | ||
+ | {{:arduino_boards:motor_control_board_test.zip|test program}} | ||
+ | |||
+ | ---- | ||
+ | **Components** | ||
* 1 H-Brigh Driver L298 N | * 1 H-Brigh Driver L298 N | ||
* 6 standard LEDs | * 6 standard LEDs | ||
Line 26: | Line 31: | ||
* 8 diodes 1N4007 | * 8 diodes 1N4007 | ||
* resistors: 2x 2,2kOhm, 2x 220Ohm | * resistors: 2x 2,2kOhm, 2x 220Ohm | ||
- | * Jumper | + | * pins and jumper |
- | + | ||
- | **=========================================================** | + | ---- |
+ | ---- | ||