Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
raspberry_boards:raspberry_io_board [2013/04/03 16:51] admin |
raspberry_boards:raspberry_io_board [2020/06/11 22:13] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | **== Raspberry In Output Board ============================** | + | ===== Raspberry GPIO Board ===== |
{{ :raspberry_boards:paper-duino-pi_0998.jpg?300 |}} | {{ :raspberry_boards:paper-duino-pi_0998.jpg?300 |}} | ||
Line 9: | Line 9: | ||
For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] | For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] | ||
- | |||
- | **== Technical documentation ==============================** | ||
The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. | The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. | ||
Line 18: | Line 16: | ||
{{ :raspberry_boards:paper-duino-pi_0989.jpg?200 |}} | {{ :raspberry_boards:paper-duino-pi_0989.jpg?200 |}} | ||
- | **== Paper-PCBs ===========================================** | + | ---- |
+ | ==== Paper-PCB ==== | ||
- | {{:raspberry_boards:raspberry_in_output_board_11.jpg?100|}} | + | {{:raspberry_boards:raspberry_in_output_board_11.jpg?300|}} |
{{:raspberry_boards:raspberry_in_output_board_11.xcf.zip|raspberry_in_output-board.zip}} | {{:raspberry_boards:raspberry_in_output_board_11.xcf.zip|raspberry_in_output-board.zip}} | ||
- | **== Components ===========================================** | + | ---- |
+ | ==== Parts ==== | ||
* 2x 26 pin female Ribbon Socket Connector | * 2x 26 pin female Ribbon Socket Connector | ||
* 26 pin male Shrouded Box Header | * 26 pin male Shrouded Box Header | ||
* flat ribbon cable (26) | * flat ribbon cable (26) | ||
- | **=========================================================** | + | ---- |
+ | ==== License ==== | ||
+ | |||
+ | The Raspberry GPIO Board was designed by **Wolfgang Spahn** 2012.\\ | ||
+ | It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]]. | ||
+ | |||
+ | <html> | ||
+ | <a rel="license" href="http://creativecommons.org/licenses/by-nc-sa/4.0/"><img alt="Creative Commons License" style="border-width:0" src="https://i.creativecommons.org/l/by-nc-sa/4.0/88x31.png" /></a> | ||
+ | </html> | ||
+ | ---- |