Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
pop_neuron:pn101_opto_synapse_osc [2018/01/11 02:04]
admin [PN101 Opto Synapse (Oscillator)]
pop_neuron:pn101_opto_synapse_osc [2020/06/11 22:13] (current)
Line 1: Line 1:
 ===== PN101 Opto Synapse (Oscillator) ===== ===== PN101 Opto Synapse (Oscillator) =====
-{{:​pop_neuron:​pn101_opto_synapse_osc_.jpg?​600|}}\\ 
-The Opto Synapse should be connected to the input of a Pop Neuron. That signal is a triangle wave and can control for example a crossmodulation.\\ 
-It uses two optocoupler for controlling two output resistors. One has to trim the two potentiometer for a wide range of the output resistor. The measure points are marked on the board. On poti is for the attenuation,​ the voltage should be peak to peak 6V. The second one rises the voltage level. The minimum voltage should be 3V. After triming the potis the signal that goes in the optocoupler should be between 3 and 9V. 
  
----- +{{:​pop_neuron:​pn101_opto_synapse_osc_.jpg?​600|}}\\
-==== Schematic ==== +
-{{:​pop_neuron:​pn101_opto_synapse_osc_schematic.jpg?​600|}}\\+
  
----- +This module is obsolete, please use the [[analog_computer:confetti502_analog_junction|Confetti502 Analog Junction]].\\
-==== Paper PCB ==== +
-{{:pop_neuron:​pn101_opto_synapse_osc_02.jpg?​300|}}\\ +
-{{ :​pop_neuron:​pn101_opto_synapse_osc_02.zip |}}\\+
  
 ---- ----