Paper-Duino-Mini


The Paper-Duino-Mini is the super reduced version of the Paperduino-Uno. It's perfect to build it in fabric for wearables or to build into (inter)active pictures.
It comes with a small power regulator and an LED on pin 13 - but that's all.
Front:

Back:

Beside the USB to Serial adapter one needs an additional programming adapter for loading up the sketches.
Front:

Back:

All about uploading a sketch without a Serial-to USB adapter one can find here: The Arduino as a Serial Adapter
And all about the bootloader is here:Burning the Bootloader


Paper-PCB

Parts

  • Atmega328
  • 1 low current LED
  • voltage converter 78M05
  • crystal 16MHz
  • 1 elkos 100µF
  • 2 capacitors 100nF
  • 2 capacitors 22pF
  • diode 1N4007
  • resistors: 1x 2kOhm, 2x 470Ohm, 1x 10kOhm
  • reset button
  • pin headers & sockets
  • battery clip

Paper-Duino-Mini

The Experimental VGA Processor was designed by Wolfgang Spahn 2016.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Creative Commons License