This is an old revision of the document!


= manual ==============================================
You need:

  • protoboard
  • printer
  • transparent paper
  • double sided tape
  • needle
  • cutter

==========================================================

- Print out the drawn circuit on transparent paper.

- Cut it out.

- Glue a doublesided tape on the back of the print.

- Mark your protoboard, 1/2, 1/3, 1/6 or what ever you need. And cut the coper side with a cutter.

- Break it into pieces on the edge of a table.

- Grind the edges with sand paper.

- Stick the printed trasparent paper on the protoboard, care about the marks. You can use needels for help.

- Cut off exess material.

- Pierce all marked holes with a needle.

- If you need holes for screws, it's a good moment for drilling them now.

- If the board will have a chips remove the copper stripes between the legs of the chip. For that, put in the chip, mark the place between the pins on the copper side and than remove the chip. Now with a cutter you can cut out the copper.

… and now, start to solder!

… et voila - a Paper-PCB.

==========================================================