Table of Contents
Raspberry GPIO Board
Here is a small connector board for the General Purpose Input/Output (GPIO) on Raspberry Pi.
This connector is a great help when you use it in combination with an breadboard.
For the GPIOs see low level peripherals
The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable.
Paper-PCB
Parts
- 2x 26 pin female Ribbon Socket Connector
- 26 pin male Shrouded Box Header
- flat ribbon cable (26)
License
The Raspberry GPIO Board was designed by Wolfgang Spahn 2012.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
