This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports.
- Forward: ON - OFF
- Stop: OFF - OFF
- Backward: OFF - ON
Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.
With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino.

motor_control_board_21.xcf.zip

test program

Components

• 1 H-Brigh Driver L298 N
• 6 standard LEDs
• 1 elkos 2200µF
• 2 capacitors 100nF
• 8 diodes 1N4007
• resistors: 2x 2,2kOhm, 2x 220Ohm
• pins and jumper

The Motor Control Board was designed by Wolfgang Spahn 2011-16.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.