Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
paper_synth:ps401_clipmixer [2017/09/09 19:19] admin created |
paper_synth:ps401_clipmixer [2020/02/14 18:31] admin |
||
---|---|---|---|
Line 13: | Line 13: | ||
All the channels sum into a channel with separate volume control, allowing 6 db of clean gain when needed. A trimmable clip led is attached to the output of the main channel, normally trimmed to light up at 10Vpp. | All the channels sum into a channel with separate volume control, allowing 6 db of clean gain when needed. A trimmable clip led is attached to the output of the main channel, normally trimmed to light up at 10Vpp. | ||
- | Three Clip Mix comes with a standard eurorack power connector, but also supports +-15V systems with small modifications. | + | ---- |
+ | ==== License ==== | ||
- | A non drilled diy aluminium faceplate is also handed at the workshop. We have a possibility to drill the faceplates in our workshop after the electronics have been built. | + | The PS401 Three To One Clipping Mixer was designed by **Antti Pussinen** 2017.\\ |
+ | It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]]. | ||
+ | |||
+ | <html> | ||
+ | <a rel="license" href="http://creativecommons.org/licenses/by-nc-sa/4.0/"><img alt="Creative Commons License" style="border-width:0" src="https://i.creativecommons.org/l/by-nc-sa/4.0/88x31.png" /></a> | ||
+ | </html> | ||
---- | ---- | ||
+ |