Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
paper_bits:pb204_sync-sequencer [2019/11/01 09:28]
admin [Manual]
paper_bits:pb204_sync-sequencer [2019/11/01 09:29] (current)
admin
Line 20: Line 20:
 If one select 1 step the Sync Sequencer goes into the **1 STEP MODE**. With the SPEED potentiometer one can now select each individual step. That makes it easy to program the sequencer.\\ If one select 1 step the Sync Sequencer goes into the **1 STEP MODE**. With the SPEED potentiometer one can now select each individual step. That makes it easy to program the sequencer.\\
  
-**change the speed:\\+**change the speed:**\\
 The speed can be set withe the SPEED potentiometer or with an external control voltage. For that the Ex-Speed switch has to be set on ON and with a jumper one can select between BUS 1 and BUS 2 as the CV source.\\ The speed can be set withe the SPEED potentiometer or with an external control voltage. For that the Ex-Speed switch has to be set on ON and with a jumper one can select between BUS 1 and BUS 2 as the CV source.\\
 If the Sync Sequencer is in the **STEP 1 MODE** instead of the speed the control voltage will change the individual step.\\ If the Sync Sequencer is in the **STEP 1 MODE** instead of the speed the control voltage will change the individual step.\\
  
-**external trigger**+**external trigger:**\\
 If one wants to use an external trigger signal one has to set the Ex-Trigger switch on ON and then use the Gate for the trigger input or instead of the TRIGGER jumper one can attache an jumper wire to the marked pin.\\ If one wants to use an external trigger signal one has to set the Ex-Trigger switch on ON and then use the Gate for the trigger input or instead of the TRIGGER jumper one can attache an jumper wire to the marked pin.\\
  
----- 
  
 +----
 ==== Paper-PCB ==== ==== Paper-PCB ====