Differences

This shows you the differences between two versions of the page.

Link to this comparison view

paper_bits:pb202_miditocv [2019/01/26 17:12]
admin
paper_bits:pb202_miditocv [2020/06/11 22:13]
Line 1: Line 1:
-=====PB202 MIDI to CV ===== 
- 
-That MIDI and MIDI over USB board give four 0 to 5V output signals, CV1, CH2, CV3 and CV4. CV1 and CV2 are filtered.\\ 
-The CCNumber are 1, 2, 3 and 4 on chanel 1. That can be easily modified in the code.\\ 
-The board also outputs a trigger signal on an clock impulse. The poti is used as a clock divider.\\ 
- 
-{{:​paper_bits:​pb202_midi_to_cv_015617.jpg|}}\\ 
- 
-For uploading code on the Arduino the Midi In jumper has to be off. One has to set the jumper for getting Midi in on the Arduino.\\ 
- 
- 
----- 
-==== Paper-PCB ==== 
-{{:​paper_bits:​pb202_midi_to_vc_22.jpg?​400|}}\\ 
-{{ :​paper_bits:​pb202_midi_to_vc_22.zip |}}\\ 
- 
----- 
-==== Software ==== 
-{{ :​paper_bits:​paperbits_miditocv_23.zip |}}\\ 
- 
----- 
-==== Parts ==== 
-  * **Resistors:​** 
-  * 1x 220 Ohm 
-  * 5x 470 Ohm 
-  * 1x 1 kOhm 
-  * 1x 3.3 kOhm 
-  * 4x 27 KOhm 
-  * **Capacitors:​** 
-  * 4x 1 nF 
-  * 4x 470 nF 
-  * **Semiconductors**:​ 
-  * Arduino Pro Micro (Atmega 32U4) 
-  * OpAmp MCP6002 
-  * Optocoupler 6N138 
-  * **Diodes** 
-  * 1x 1N4148 
-  * **Potentiometer:​** 
-  * 1x 100 kOhm 
-  * **Mechanical:​** 
-  * 1x IC socket, 28 pin 
-  * 2x IC socket, 8 pin 
-  * 1x pin strip 1x10 pin 
-  * 2x pin header, female 12 pin 
-  * 2x pin header, female 90° 1x3, 1x2 
-  * 2x pin header, male 90° 1x3, 1x2 
-  * 2x push button 
-  * 3x jumpers 
- 
----- 
-~~socialite:​icon facebook twitter googleplus reddit tumblr~~ 
- 
----- 
-