This is an old revision of the document!
== Burning the Bootloader ==============================
For burning the bootloader you need to connect the following pins on your Paperduino-UNO with your ISP programmer (in-system programmer):
- 11 - MOSI
- 12 - MISO
- 13 - SCK
- Reset
- Ground
- + 5V
== Burning the bootloader with an AVR programmer ======
On the foto you see the ISP programmer with an ISP adapter board. Here are the connection of an original ISP header.
Cause my ISP programmer has a different protokoll as the originale AVR-ISP programmer I had to modifie the file:
programmers.txt
in that folder(on Linux):
/usr/share/arduino/hardware/arduino
The third line has to change to:
avrisp.protocol=stk500v1“
== Burning the bootoloader with an Arduino ===============
You can use your Arduino to burn the bootloder. Just load the ArduinoISP (in examples) on your Arduino. Connect the pins like that:
===========================================================