Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
analog_computer:confetti502_analog_junction [2019/07/01 20:13]
admin [Paper PCB]
analog_computer:confetti502_analog_junction [2020/06/11 22:13] (current)
Line 6: Line 6:
 But for the input any other voltage source could be used, too.\\ But for the input any other voltage source could be used, too.\\
  
-The board behaves at the output like a variable resistor. An other resistor could be plugged in the socket ​to put it in series to the one on the board. If no resistor is needed a wire should be plugged in the sockets.\\+The board behaves at the output like a variable resistor ​in the range from 95 Ohm to 370 KOhms. An other resistor ​or a diode could be plugged in the socket. That will be now in series to the one on the board. If no resistor is needed a wire should be plugged in the sockets.\\
  
 For the design two H11F1 optocoupler are used to control two output resistors. One has to trim the two potentiometer for the ideal control of the output resistor range. The two measure points Vpp and Vmin are marked on the board. One potentiometer is for the attenuation,​ the voltage at Vpp should be peak to peak 6V. The second potentiometer adjust the voltage level. The minimum voltage should be 3V.\\ For the design two H11F1 optocoupler are used to control two output resistors. One has to trim the two potentiometer for the ideal control of the output resistor range. The two measure points Vpp and Vmin are marked on the board. One potentiometer is for the attenuation,​ the voltage at Vpp should be peak to peak 6V. The second potentiometer adjust the voltage level. The minimum voltage should be 3V.\\
Line 16: Line 16:
 {{:​analog_computer:​confetti502_analog_junction_01.jpg?​400|}} {{:​analog_computer:​confetti502_analog_junction_01.jpg?​400|}}
 {{ :​analog_computer:​confetti502_analog_junction_01.zip |}}\\ {{ :​analog_computer:​confetti502_analog_junction_01.zip |}}\\
 +
 +----
 +==== License ====
 +
 +The Confetti502 Analog Junction was designed by **Wolfgang Spahn** 2015-19.\\
 +It is licensed under a [[http://​creativecommons.org/​licenses/​by-nc-sa/​4.0/"​|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]].
 +
 +<​html>​
 +<a rel="​license"​ href="​http://​creativecommons.org/​licenses/​by-nc-sa/​4.0/"><​img alt="​Creative Commons License"​ style="​border-width:​0"​ src="​https://​i.creativecommons.org/​l/​by-nc-sa/​4.0/​88x31.png"​ /></​a> ​
 +</​html>​
  
 ---- ----