Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
about:smd-soldering [2014/07/15 20:29]
admin
about:smd-soldering [2020/06/11 22:13] (current)
Line 1: Line 1:
 ---- ----
-**SMD Solder Manual**+==== SMD Solder Manual ​====
 ---- ----
  
-For SMD soldering one needs rosin (also called colophony) +For SMD soldering one needs rosin (also called colophony)It helps the molten metal to flow and makes a better connection. ​Use it with alcohol and a brush.\\ 
-It helps the molten metal to flow and making ​a better connection. Because SMDs are super small a magnifying glass could help a lot, too.\\+Because SMDs are super small a magnifying glass could do magic, too.\\
 {{ :​about:​smd-loeten_00.jpg?​300 |}}\\ {{ :​about:​smd-loeten_00.jpg?​300 |}}\\
-And certainly one needs all the standart ​solder ​tools.\\+And certainly one needs a normal solder iron and all the standart tools for soldering.\\
 \\ \\
 1. One need a protoboard for the SMD chip.\\ 1. One need a protoboard for the SMD chip.\\
Line 16: Line 16:
 4. And some solder, too.\\ 4. And some solder, too.\\
 {{:​about:​smd-loeten_04.jpg?​200|}}\\ {{:​about:​smd-loeten_04.jpg?​200|}}\\
-5. Check with the magnifying glass if there no briges.\\+5. Check with the magnifying glass if there are no bridges. To remove these use desoldering braid.\\
 {{:​about:​smd-loeten_05.jpg?​200|}}\\ {{:​about:​smd-loeten_05.jpg?​200|}}\\
-6. Again rosin.\\+6. Again some rosin.\\
 {{:​about:​smd-loeten_06.jpg?​200|}}\\ {{:​about:​smd-loeten_06.jpg?​200|}}\\
 7. Bring the chip in the right possition.\\ 7. Bring the chip in the right possition.\\
 {{:​about:​smd-loeten_07.jpg?​200|}}\\ {{:​about:​smd-loeten_07.jpg?​200|}}\\
-8. Solder one leg, check if the possition is OK.\\+8. Solder one leg without any extra solderjust melt the one on the pads. Check if the possition is OK, than solder all the other pins, again no solder is needed.\\
 {{:​about:​smd-loeten_08.jpg?​200|}}\\ {{:​about:​smd-loeten_08.jpg?​200|}}\\
 +9. Check all connections and the pins for bridges. If there is one desolder it with a desoldering braid.\\
 {{:​about:​smd-loeten_09.jpg?​200|}}\\ {{:​about:​smd-loeten_09.jpg?​200|}}\\
 +10. Solder some proper pins on the board, too.\\
 {{:​about:​smd-loeten_10.jpg?​200|}}\\ {{:​about:​smd-loeten_10.jpg?​200|}}\\
  
 ---- ----