===== Raspberry GPIO Board ===== {{ :raspberry_boards:paper-duino-pi_0998.jpg?300 |}} Here is a small connector board for the General Purpose Input/Output (GPIO) on Raspberry Pi.\\ This connector is a great help when you use it in combination with an breadboard. {{ :raspberry_boards:paper-duino-pi_0993.jpg?200 |}} For the GPIOs see [[http://elinux.org/Rpi_Low-level_peripherals|low level peripherals]] The board is desined with just a smal piece of strip grip board, two socket connector for flat ribbon cable, one shrouded box header - both with 26 pins (2 x 13) and a piece of flat ribbon cable. {{ :raspberry_boards:paper-duino-pi_0984.jpg?200 |}} {{ :raspberry_boards:paper-duino-pi_0989.jpg?200 |}} ---- ==== Paper-PCB ==== {{:raspberry_boards:raspberry_in_output_board_11.jpg?300|}} {{:raspberry_boards:raspberry_in_output_board_11.xcf.zip|raspberry_in_output-board.zip}} ---- ==== Parts ==== * 2x 26 pin female Ribbon Socket Connector * 26 pin male Shrouded Box Header * flat ribbon cable (26) ---- ==== License ==== The Raspberry GPIO Board was designed by **Wolfgang Spahn** 2012.\\ It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]].

----